![]() A RAID volume rather than a RAID controller R device |Ĭhannel: target Manually kick off a rebuild of a RAID volume, usingĭevice must be specified as a full path to the chunkĭevice file (e.g. q Show vendor, product, revision, and serial number for the given disk. In order to reduce the number of digits to four or less. Suffixes: Byte, Kilobyte, Megabyte, Gigabyte, Terabyte, Petabyte, Exabyte ![]() h Where necessary, produce “human-readable” output. Is currently marked “Unused”, promote it to being a b channel: target Instruct the device atĮnclosure. Given above, or by the first letter only (e.g. Quiet Silence the alarm if it is currently beeping. get Retrieve the current alarm state (enabled or disabled). enable Enable the alarm on the RAID controller. The options for RAID controllers are as follows: -a alarm-function Control the RAID card's alarm functionality, if supported.ĭisable Disable the alarm on the RAID controller. For operations which will be performed againstĪlso possible to directly specify the enclosure name (e.g. In the first synopsis, RAID controllers are managed.ĭevice specifies either a drive (e.g. RAID device drivers which support management functionality can
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |